ENJOY VS500 Spa Pak Owner's Manual download pdf (Page 24)

Controller Instructions

Initial Start up / Temperature setup

Whenyourspaisrstactuated,itwillgointoPrimingmodewhich

is indicated by “Pr”. This Priming mode will last for 5 minutes and

then the spa will begin to heat the spa and maintain the water tem-

perature in the Standard Mode.

Temp/Set (80°F - 104°F / 26°C - 40°C)

The start-up temperature is set to 100°F/37°C. The Last mea-

sures temperature is constantly displayed on the LCD.

NOTE: The last meausred spa temperature displayed is current

only when the pump has been running for at least 2 minutes.

To display the set temperature, press the “Cool” or “Warm” pad

once.

To change the set temperature, press the pad a second timebe-

foretheLCDstopsashing.Eachpressofthe“Cool”or“Warm”

pad will continue to either lower of raise the set temperature

respectively.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 58 59

No comments

ENJOY VS500 Spa Pak Owner's Manual Page 24